Before shredding the 670 paper cutter, check whether there are paper clips, staples and other hard objects on the documents to be shredded. If there is, it should be removed and put into the paper port, otherwise the cutter may be damaged. When using the 670 cutter, be careful not to jam too much paper at a time, especially paper of better quality, and pay more attention when using it, so as to avoid paper jams. Try not to skew the paper when loading it. The paper should be placed in the center of the paper inlet as much as possible.
For early products, once a paper jam occurs during use, you should press the rewind key or the stop key to enable the crush to continue to be used. Most of the 670 paper cutters are equipped with overload power-off protection devices. When the motor overloads and heats up, it will automatically stop. At this time, the use of 20-30min should be stopped to cool the motor. At the same time, when using it again, you should consider reducing the amount of input paper appropriately. The more advanced 670 paper cutter will automatically stop and automatically eject the paper once it is overloaded, making it more convenient to use. When the box of the 670 paper cutter is full, some machines will automatically make a sound to remind people to remove paper scraps in time.
