Brief Introduction to Adjustment Steps of Blades in Programmed Paper cutter 2
Next, we need to determine the cutting depth of the blade. At this point, we can use a socket wrench to rotate the nut on the end face of the pulley, so that the cutting bed can move to a certain lowest point. At the same time, we need to observe the depth of the blade to see if it is reasonable. Generally, the cutting depth of the blade is 0.5 to 1 mm.
For the adjustment process of the blade, if only one end of the blade edge and blade can be contacted, we can solve it by adjusting the eccentric shaft behind the main frame; When the blade cannot cut the paper properly due to wear and tear, we can move the blade downwards along its long hole direction until it can completely cut the paper.
